Exhibition

Home > Exhibition > Content
How to do the phenomenon of dripping in the atomizing nozzle
Dec 24, 2017

How to do the phenomenon of dripping in the atomizing nozzle

Some friends have met with feedback, saying that a batch of atomizing nozzles have been bought in a certain factory. After a period of time, the phenomenon of drip water appears. What is the principle that causes the atomizing nozzles to drop water? Today, Zhuji sea airlines will take everyone to see it.


1, waterproof ring missing atomizing nozzle, leak proof device corrosion, damage phenomenon.


2, the connection of atomizing nozzles appears problems, resulting in poor sealing.


3. The thread interface of the atomizing nozzle is not fully connected.


In general, the cause of the drop of the atomizing nozzle is three points above, so what should we do at this time? In fact, it is very simple, that is to repair the problem of atomizing nozzles, if the atomizer is damaged, the new nozzle can be replaced. From this problem, it can be seen that it is very important to choose the atomizing nozzle. If the quality of the atomizing nozzles produced by the selected manufacturers is not clear, these problems are especially easy to occur.

ZHUJI HAIHANG MISTING EQUIPMENT CO., LTD

Contact:ZHANGKAI ZHAO

Tel:+86-575-87061046

Email:info@hmisting.com

Mobile:8613735217187

Skype:edwardzzk2








Copyright © Zhuji Haihang Misting Equipment Co.,Ltd All Rights Reserved.Tel: +86-575-87061046