Installing an atomizing nozzle seems simple, but if you do not pay attention to the small details of the installation, it will also affect the spray effect and service life of the air atomizing nozzle. What details should be paid attention to when installing an atomizing nozzle?
1. The atomization nozzle should be installed after the system is tested and flushed.
2. When the atomizing nozzle splashing tray is higher than the ventilated surface or beam bottom of the ventilation duct with a width less than 1.2m, the vertical distance between the atomizing nozzle splashing tray and the ventilated surface of the ventilation duct should comply with the relevant standards.
3. When installing atomization nozzle, it is suitable to use corresponding special elbows and tees.
4. For atomizing nozzles installed in places that are prone to mechanical damage, an atomizing nozzle protective cover needs to be added for spraying.
5. When the atomization nozzle is installed near the partition that is not top, the horizontal distance and minimum vertical distance between the atomization nozzle and the partition should be subject to the relevant standards.
6. When the nominal diameter of the atomization nozzle is less than 10 mm, a filter needs to be installed on the water distribution pipe or water distribution pipe.
7. When installing an atomization nozzle, it must meet the design requirements of the distance between the splashing tray and the ceiling, doors, windows or walls.
8. When installing an atomization nozzle, the atomization nozzle cannot be disassembled or modified, and any decorative coating cannot be applied to the atomization nozzle.
9. When the width of the ventilation duct is greater than 1.2 meters, the atomization nozzle should be installed below the abdomen of the ventilation duct.
10. When installing atomizing nozzle, you must use the installed special wrench. You cannot use the frame of the atomizing nozzle to twist, because the frame of the atomizing nozzle and the splashing tray will cause deformation, causing damage to the original release. At this time, you must use the corresponding atomizing nozzle with the same specifications and models to replace it.
